Rear Blinking Fog Light Fix for Range Rover L322 2010 (02-05 cars)

Fog Light "blinking" Fix kit ( PAIR )

to fit Range Rover L322 2010

LED Rear light Conversion on 02 - 04 cars

This listing is for 2 x printed circuit boards that fix the "blinking" fog lights on the 2010 LED rear lights when fitted to the early model L322.

This kit is for cars from 2002 to 2005 ( pre-facelift models )

The problem is that the ECU sends a check pulse to the rear fog light to check the bulb circuit and this is fine on the old model lights with the filament type bulbs but when you fit the LED bulbs the tiny pulse is enough to light up the LED's and make your Range Rover look like a mobile disco.

Please note this is only the FOG light fix ( the light inside the LED circle ) it does not stop the initial flashing of the out LED ring ( tail light )

We have tried various ways to fix this but this package is the most cost effective way we have found.

This problem is on both rear lights so this kit is a PAIR of circuit boards one for the LEFT and one for the RIGHT ( both are the same )

This board has been designed with screw terminals to make the wiring easy

The only wire you need to cut is the wire going to pin 3 ( fog light ) the other wires you only need to tap into.

We also supply 2 cut lengths of heat shrink sleeving that you use to enclose the circuit board when the wiring is completed ( and tested ).

We also supply 4 scotch block connectors that "tap" into the earth / tail light wires to simplify wiring ( soldered connections are better if you have the facility to do this )

This circuit is small enough to sit between the rear light and the inner panel or you could extend some wires and fit in inside the car behind the rear trim.

We cannot guarantee that this will stop any error messages on the dash display.

This works on most standard cars 2002 -2004 but we have had a few customers where it has not worked - this could be due to other changes on the car like tow bar electrics / headlight conversions. Therefore we cannot guarantee that this will solve your problem, but you can return it for a refund if it does not work for you.

These are not genuine Land Rover parts.

Fitting Details

Remove the rear lights

Following the diagram to make the connections

Test the function of all the lights. There should be no buzzing.

When you are happy all functions are working slide the heat shrink sleaving over the circuit board and then apply heat ( heat gun ) to shrink the tube over the circuit.

The circuit will sit between the rear light and the inner panel.

Which Vehicles will this fit ?

This item will fit Range Rover L322 models from 2002 to 2005 when fitting 2010 LED rear lights ( with LED indicators )