Late Type PDC connectors ( x4 )
for Range Rover L322 2010 -13 Front / Rear Bumper
The parking sensors on the Range Rover L322 changed to a smaller type in 2010 so when you change an earlier model to a 2010 front bumper ( standard type or design pack type ) you will need to fit new parking sensors.
The problem is that the new parking sensors have a different connector on them so that the plugs on the car wiring loom dont fit the new PDC sensors.
The solution is to cut off the old plugs from the loom and replace them with these new type connectors.
When fitting these the best way is to solder and use heatshrink over the solder joints.
This listing is for 4 connectors each with a short length of wire for you to solder to the original car loom - you will need 4 for the rear bumper and 4 for the front bumper conversion.
The sensors themselves are not included in this sale - see our other items for the actual sensors.
This is not a genuine Land Rover item.
Fitting Instructions
You need to cut off your old connectors and solder these in their place.
Front Electrical Conversion see below video
Range Rover L322 2006 to 2010 Conversion - Front Electrical Changes - YouTube
Video will open in a new window
Which Vehicles will this fit ?
This item WILL fit Later type PDC sensors used on the Range Rover L322 from 2010 onwards
- Choosing a selection results in a full page refresh.
- Opens in a new window.