Electrical Resistor for Range Rover L322 Heater blower (Genuine)

Genuine Heater Blower Resistor

for Range Rover L322 Vogue 2002 - 2009

This listing is for a Range Rover final stage heater fan blower resistor.

This is the resistor that gives you the various fan speeds on the heating and air conditioning.

These fail and have several results.

1) A flat battery when the car is not used for a few days

2) Strange fan speeds

3) Fan only works on full speed.

The early 2002 to 2004 cars had a version of this that gave a lot of problems so these have been replaced with this part number.

Its a 10 minute job to change and it "clips" into place so its not too difficult to change.

This is a genuine Land Rover item, brand new in retail packaging.

Fitting Details

Remove the screws holding on the cover panel above the foot pedals and remove this cover.

On the left side you will see the connector plug as shown in the picture - do not unclip this !

To one side of the connector there is a plastic clip that holds the resistor in place - push this to one side and pull on the wires to release the resistor from the heater housing.

In addition to my pictures there is a neat write up on the following website

http://bimma.me.uk/2009/03/13/replacing-the-final-stage-blower-resistor-on-a-l322-range-rover-mkiii-2002/

Which Vehicles will this fit ?

This item will fit Range Rover L322 models from 2002 to 2009.

These WILL NOT fit a Range Rover P38, SPORT